Recoil PX65.4 Review: 6.5-Inch Neodymium Coaxial, Specs and Price
The Recoil PX65.4 is a 6.5-inch (165 mm) 2-way coaxial speaker with a neodymium magnet, a bullet tweeter and a 1.52 in (38.5 mm) voice coil. Our listing gives 150 W RMS and 300 W peak at 4 ohm, 95 dB sensitivity and a 110 Hz to 20 kHz response. The Indian MRP is ₹36,000, against ₹15,000 for the Recoil MX65 and ₹10,000 for the RX65-4P coaxials we also list. The listing does not say whether the power figures apply per speaker or per pair, and we found no PX65.4 page on Recoil's website. See our Recoil PX65.4 product page.
Key takeaways
Every figure here comes from our listing. We found no PX65.4 page on Recoil's website to cross-check it.
The 150 W RMS and 300 W peak ratings carry no per-speaker or per-pair label, and the listing does not say how many speakers are sold. Confirm both with Recoil or its distributor.
On paper, 95 dB is higher than the MX65's 93.5 dB and the RX65-4P's 90 dB, and the magnet is neodymium where both use ferrite.
The response starts at 110 Hz, so bass needs a subwoofer. We found no owner reviews.
Recoil PX65.4 specifications
Specification | Recoil PX65.4 |
|---|---|
Type | 6.5-inch (165 mm) 2-way pro audio coaxial with bullet tweeter |
Magnet | Neodymium (weight not listed) |
RMS power | 150 W (per speaker or per pair not stated) |
Peak power, not RMS | 300 W (per speaker or per pair not stated) |
Impedance | 4 ohm |
Sensitivity | 95 dB |
Frequency response | 110 Hz to 20 kHz |
Voice coil | 1.52 in (38.5 mm) |
Cone | Waterproof paper (per our listing) |
Speakers per sale, mounting depth, cut-out size | Not stated |
Warranty | Per Recoil's published terms (written for the US); confirm India terms with Recoil or its distributor |
India MRP | ₹36,000 |
Every figure above comes from our store listing, because we found no PX65.4 page on Recoil's site in October 2026. The nearest, for the HX65.4, is a different model with a ferrite magnet, 93 dB and an 80 Hz low end, so it cannot stand in for this data sheet. Recoil's terms are on its warranty page.
Neodymium motor, 1.52 in coil and a waterproof-paper cone
The listing describes a neodymium magnet motor, built for high-output systems where power handling and tonal accuracy both matter, with the 1.52 in voice coil credited for heat dissipation and power handling. It calls the paper cone waterproof, for exposed or high-humidity installations. That covers the cone only: the listing gives no ingress-protection rating for the whole speaker, so keep it out of direct spray. No magnet weight or voice-coil material is given, so there is no like-for-like figure against the 20 oz ferrite magnet in the MX65 or the 17 oz one in the RX65-4P.
Power ratings with no stated basis
The listing gives 150 W RMS and 300 W peak and stops there. Read as per speaker, a pair handles 300 W RMS in total; read as per pair, each speaker is rated 75 W RMS. That factor of two matters when you choose an amplifier. The 300W in the product title matches the peak figure, but it would also equal a pair's RMS total under a per-speaker reading, so the name alone does not tell you the RMS rating. Recoil's own general buying guide, which is promotional, says the RMS rating matters more than the peak rating and that amplifiers should be matched to it.
For scale, the Recoil RL680.4 amplifier is listed at 95 W per channel at 4 ohm (14.4 V) with no RMS, peak or max label, so we do not call it RMS. As a number it is below the 150 W of a per-speaker reading but above the 75 W each that a per-pair reading gives, so set gains with care until you know which applies.
What 110 Hz to 20 kHz means in a door
A response starting at 110 Hz makes the PX65.4 a midrange-and-treble driver, not a speaker that supplies its own bass. You would pair it with a subwoofer and a high-pass filter to keep deep bass away from it, set on a DSP or an amplifier's crossover. The listing gives no crossover advice, so filter points would come from your installer or tuning. Our guide to why a DSP matters in car audio explains the basics.
What owners and reviewers say about the Recoil PX65.4
We found nothing to report. When we checked in October 2026, Recoil's website had no PX65.4 page. The retailer, forum and Reddit pages we tried were blocked, returned errors or came back empty, and we had no web search available, so we read no independent owner thread or test. That limits our check; it does not prove that nobody has written about the speaker. If you have fitted a pair, tell us in the comments which car and amplifier you used, and whether the pack and ratings matched what you expected.
Recoil PX65.4 vs MX65 and RX65-4P
The Recoil MX65 (₹15,000 MRP) is a coaxial pair with built-in bullet tweeters and crossover filters, listed at 280 W RMS and 560 W max per pair, or 140 W RMS and 280 W max per speaker, with 93.5 dB, a 1.5 in Kapton coil and a 20 oz ferrite magnet. The Recoil RX65-4P (₹10,000 MRP), from the Red Storm series, is listed at 100 W RMS and 200 W max with no per-speaker or per-pair label, plus 90 dB, a 114 Hz to 20 kHz range, a 17 oz ferrite magnet and a 57 mm mounting depth.
On the listed figures, the PX65.4 differs from both by its neodymium magnet and higher sensitivity: 95 dB is 1.5 dB above the MX65 and 5 dB above the RX65-4P. Its MRP is ₹21,000 above the MX65's, though the MX65 is sold as a pair and the PX65.4's pack is not stated. The listing does not explain the gap beyond those differences, so ask Recoil or its distributor what else separates the models before you pay it.
Who should buy it, and who shouldn't
Buy the PX65.4 if you specifically want a neodymium 6.5-inch coaxial with 95 dB sensitivity, you have confirmed the pack contents and power basis with Recoil or its distributor, and you plan a subwoofer for the low end.
Look elsewhere if you need a documented per-speaker power rating, mounting depth or magnet weight before you spend: the MX65 states its power per speaker and the RX65-4P publishes a mounting depth. For a modest upgrade over factory speakers, our guide to car speakers under ₹10,000 is a better start.
Installation notes for Indian cars
Mounting depth and cut-out size are not listed, so treat fitment as unconfirmed and measure behind the door skin with the window fully down. If depth is tight, a baffle or pod is the usual fix; VA3 Car Studio in Ghaziabad builds custom speaker pods and door baffles, and offers professional installation and DSP tuning. The listing does not describe how the bullet tweeter is filtered or wired, so confirm that with Recoil or its distributor before you plan the wiring. Our guide to applying sound damping in a car covers stopping door panels buzzing on rough roads.
Price and where to buy
The Recoil PX65.4 carries an India MRP of ₹36,000. VA3 Car Studio often sells below MRP, so check the current offer on the PX65.4 product page, and confirm the pack contents with Recoil or its distributor first, since the listing does not state them.
The bottom line
The Recoil PX65.4 is a 6.5-inch neodymium coaxial with the highest listed sensitivity of the three Recoil coaxials compared here, at a much higher MRP. But the listing leaves out the power basis, pack contents, depth and the tweeter's filtering. Settle those points before you buy, and plan a subwoofer. If you cannot, the better-documented MX65 is the safer choice.
Recoil PX65.4 FAQ
What is the Recoil PX65.4's RMS power?
Our listing gives 150 W RMS and 300 W peak at 4 ohm. It does not say whether those figures are per speaker or per pair, and the 300W in the product title matches the peak figure but could also be a pair's RMS total, so the name alone does not give the RMS rating. Confirm the basis with Recoil or its distributor before sizing an amplifier.
Is the PX65.4 sold as a pair?
The listing does not say. Its title does not use the word pair and its ratings carry no per-speaker or per-pair label, so confirm the pack contents with Recoil or its distributor before ordering.
Is the Recoil PX65.4 waterproof?
The listing describes the cone as waterproof paper, for exposed or high-humidity installations. It gives no rating for the whole speaker, so keep it out of direct spray and rely on the door's water barrier.
Does the PX65.4 have owner reviews?
None that we could find. Recoil's website has no PX65.4 page, and the retailer and forum pages we could read had nothing on it. Owners are welcome to share their experience in the comments.
Comments